You can always delete a wire or a connection point by clicking on it and pressing delete. Wires are connected to other wires where there is a red dot. If you try to wire straight from one node to the other then the program will automatically place a wire but often this will go over other components in the schematic or connect to other wires which you don t want it to. To finish putting down the wires right click and select End Wire.
Once this option is selected click on the top node of the battery then move the mouse up so that the wire goes in a straight line and click again and then move the mouse right so the wire goes in a straight line and click directly above the first resistor and then move straight down and click on the node of the resistor.Īt the moment the Place Wire tool is still selected so you can go to the other nodes in the circuit and complete the wiring. You can place wires between components in the schematic by going to the Place menu and selecting Wire or you can click on the Place Wire symbol which is found on the right hand side of the screen and is the third symbol from the top. You can rotate the component while placing it by pressing Ctrl-R or you can select the part and go to the Edit menu and select the Rotate option.ĩ We need to wire up the resistors so that they are in series with the DC voltage source. #Pspice schematics 9.1 citation series#.
0 kommentar(er)
